NOT Gate Based Monostable Multivibrator PCB Design

 

Introduction

This is a PCB design of a NOT gate-based monostable multivibrator circuit. In this PCB, you can see a push switch that works as an input and you can also see an LED that works as an output indicator.

Working of this PCB

When we connect this PCB to a 5V DC power source then it will start working. When we press the push switch for a short time then the LED will turn on and remain on even after we release the push switch. The LED will remain on until the RC time constant completes.

Front or Top Side View

In the image below, you can see how this PCB will appear from the top or front side after manufacturing. The components are clearly visible on the top side of the PCB in the provided image

Bottom or Back Side View

In the image below, you can see how this PCB will look from the back or bottom side after manufacturing. On the bottom side, you can observe the appearance of all solder pads.

How to Download Gerber File

You can download the Gerber file of this PCB from the link below. Along with the Gerber file, you will also receive the schematic file of this PCB.

Download Gerber File

You should read this: - Half Adder Using BJT or Transistor PCB Gerber File